Asko DC7171 User manual Use & Care Guide ASKO DC7171 EN - Page 24
Troubleshooting - washing machine
View all Asko DC7171 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Troubleshooting Before calling for help, first try to correct the problem using the following guide: Problem Garments are not being dried as expected. Cause The house breaker for drying cabinet has tripped. Corrective action Check. Cycle control and/or time switch has not been correctly set. Check the setting. The drying cabinet is being used in a room with a temperature lower than 0°C (32°F). Normal operation requires installation in a room with a temperature over 0°C (32°F). Poorly spun-dried items or too If the clothing is too wet, much remaining moisture in use a higher spin speed on the garments. the washing machine. Has the items been hung correctly? See the section "Loading". Have the time and temperature Increase the program knobs been for too little time length and temperature to or a temperature too low? achieve the desired level of dryness. Is the vent pipe/hose too long? Length should not exceed 39 inches (1 m). The drying cabinet does not produce enough heat even thought the cycle control is activated. Is the power plug inserted? Check. Is the drying cabinet door closed? Push firmly on the door to make sure it is closed. Was the "START" button fully Press the button again. depressed? Has the time switch been set? Check. The overheating protector has Turn the time switch back tripped. to "0" and wait 30 minutes. After 30 minutes has passed, turn the time switch to 30 minutes and press the "Start" button. The overheating protector is faulty. Contact our Customer Care Center. 24 Customer Care Center 1-800-898-1879 www.askousa.com