Asko DFI564 Instructions for use - Page 34

Troubleshooting Problem Possible causes Action Spots or films on the dishes. Incorrect rinse aid dosage setting. See the chapter Settings. The TAB setting is activated and Switch all-in-one detergents or all-in-one detergent with deactivate the TAB setting and insufficient drying effect is being fill up with separate rinse aid. used. See Rinse aid in the chapter Settings. Too high temperature and/or too Wash crystal at a low much detergent can cause temperature and with a etching on crystal. conservative amount of Unfortunately, this cannot be detergent. Contact the detergent repaired, only prevented. manufacturer. The dishes have a sticky white/blue film. Rinse aid dosage setting too high. Reduce the dosage. See the chapter Settings. If you have very soft water, you may want to dilute the rinse aid 50:50 with water. Spots left after washing. Lipstick and tea/coffee stains Use a detergent with a can be difficult to remove. bleaching agent. Detergent residue in the detergent compartment after dishwashing. The detergent compartment was The detergent compartment damp when adding detergent. must be dry when adding detergent. The detergent compartment has Check that the dishes are not been blocked. preventing the detergent compartment from opening. Rattling sound when dishwashing. The dishes are not correctly Check that the dishes are placed or the spray arms are not placed securely. Spin the spray rotating. arms to make sure they can rotate. "Program paused" is shown on the display. The dishwasher door has been If you want the dishwashing opened while a program is in program to continue, press progress. and close the door within four seconds. If you want to cancel the dishwashing program, press and hold for three seconds. 34