Asko T761 User manual Use & Care Guide Asko T701,721,761,781 - Page 6
Electrical Connections - electric dryer
View all Asko T761 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ELECTRICAL CONNECTIONS The power supply cord must be grounded. If the machine is to be used in a wet area, the supply must be protected by a residual current device. NOTE: In Canada, the dryer is delivered ready-fitted with a four-prong plug intended for connection to a singlephase supply. Remove cover to access terminal box. (Requires a 20-Torx screwdriver.) CONNECTING A 3-WIRE POWER CORD WARNING! Before starting this procedure, be sure the power is turned off at the breaker/fuse box. Power Supply Cord You will need a 3-wire power supply cord with three No. 10 copper wires and a matching 3-wire receptacle of NEMA Type 10-30R, as illustrated below: 3-WIRE CORD Spade terminals with upturned ends This blade connects to this conductor. Ring terminals Neutral 3/4" UL-listed strain relief Neutral (white) CONNECTING A 4-WIRE POWER CORD WARNING! Before starting this procedure, be sure the power is turned off at the breaker/fuse box. Power Supply Cord You will need a 4-wire power supply cord with four No. 10 copper wires and a matching 4-wire receptacle of NEMA Type 14-30R, as illustrated below. The fourth wire must be identified with a green cover and the neutral conductor by a white cover. 4-WIRE CORD Neutral Spade terminals with upturned ends 3/4" UL-listed strain relief Ring terminals Ground prong Ground (green) Neutral (white) Page 6 Connection to a permanently wired supply point must be made only by a qualified electrician. As supplied: Single-phase, 230 V, 60 Hz, 2500 Watt heater rating 30 A fuse required WARNING: The receptacle on the rear of the machine is designed to accommodate ASKO washers ONLY (rated 208-240 V.) To use this receptacle, you must use the ready-fitted plug supplied with the washing machine or an equivalent. The supply connection must be 208-240 V, 20 A. ASKO washers rated 208-240 V have two internal fuses of 15 A each. 1. Turn the power off at the breaker/fuse box. 2. Remove terminal block cover. 3. Use the strain relief attached below the terminal block opening. 4. Loosen or remove center terminal block screw. 5. Connect neutral (white ) wire of power supply cord to the center, silver-colored terminal screw. Tighten screw. 6. Connect the other wires to outer screws. 7. Tighten the strain relief screws. 8. R e p l a c e t e r m i n a l box cover on back of dryer. 9. Plug dryer into wall receptacle. 10. Tu r n p o w e r o n a t breaker/fuse box. 1. Turn the power off at the breaker/fuse box. 2. Remove terminal block cover. 3. Use the strain relief attached below the terminal block opening. 4. Remove center terminal block screw. 5. Remove ground wire (green with yellow stripes) from external ground connector screw. Fasten under center, silver-colored terminal block screw. 6. Connect ground (green) wire of cord to external ground conductor screw. 7. Connect neutral (white) wire of cord under center screw of terminal block. 8. Connect the other wires to outer screws. 9. Tighten the strain relief screws. 10. Replace terminal box cover on back of dryer. 11. Plug dryer into wall receptacle. 12. Turn power on at breaker/fuse box.