Asko TL751XXL User manual 20 200 20 Asko TL751 XXL EN - Page 23

Installation instructions Caution! - Risk Of Fire • Dryer installation must be performed by a qualified installer. • Install the dryer according to the manufacturer's instructions and local codes. • Do not install a dryer with flexible plastic venting materials. If flexible metal (foil type) duct is installed, it must be of a specific type identified by the appliance manufacturer as suitable for use with dryers. Flexible venting materials are known to collapse, be easily crushed, and trap lint. These conditions will obstruct dryer airflow and increase the risk of fire. • To reduce the risk of severe injury or death, follow all installation instructions. • Save these instructions. Step 1. Positioning the tumble dryer Choose a location with a solid floor for your dryer. Place the dryer in the desired location and please make sure that it has the required 40 3/8" (102.5cm) 27" (68.6cm) 52" (132cm) 32" (81.2cm) The following instructions will guide you through the initial steps of setting up your dryer. Please note that every section of this manual provides important information regarding the preparation and use of your dryer, and it is important that you review this entire manual before proceeding with any installation or use. More detailed instructions concerning electrical connections, gas connections, and exhaust requirements are provided in other parts of this manual. clearances shown below. • Most installations require a minimum 6" (15.2 cm) clearance behind the dryer for the exhaust vent with elbow. Note! Leveling legs should be secured. All four legs should be stably placed on a solid and even floor. If dryer is not level, laundry may not tumble properly and sensor will not detect humidity information accurately. When leveling, please be cautious not to injure your fingers and toes. If you install the dryer on the optional pedestal, it is necessary to level with the pedestal leveling legs. Customer Care Center 23 1-800-898-1879 www.askousa.com