Asus A7V333 A7V333 User Manual - Page 84
I/O Device Configuration - driver
View all Asus A7V333 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
4.4.2 I/O Device Configuration Onboard FDC Swap A & B [No Swap] This field reverses the hardware drive letter assignments of floppy disk drivers. Configuration options: [No Swap] [Swap AB] Floppy Disk Access Control [R/W] This field sets the capacity of the floppy disk drivers to read and/or write. Configuration options: [R/W] [Read only] Onboard Serial Port 1 [3F8H/IRQ4] Onboard Serial Port 2 [2F8H/IRQ3] These fields set the addresses for the onboard serial connectors. Serial Port 1 and Serial Port 2 must have different addresses. Configuration options: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10] [Disabled] UART2 Function Selection [COM2] This field selects the device on which to assign UART2. (Only the COM2 or the infrared, or the Smart Card Reader may be supported at any given time. Configuration options: [COM2] [Standard Infrared] [Smart Card Reader] Onboard Parallel Port [378H/IRQ7] This field sets the address of the onboard parallel port connector. If you disable this field, the Parallel Port Mode and ECP DMA Select configurations are not available. Configuration options: [Disabled] [378H/IRQ7] [278H/IRQ5] 68 Chapter 4: BIOS Setup