Asus AAM6030BI User Manual - Page 21
Static IP address assignment
View all Asus AAM6030BI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
AAM6030BI User Manual Figure 10 (Example of a DHCP Relay configuration) By turning off the DHCP server and relay the network administrator must carefully configure the IP address, Subnet Mask and DNS settings of every computer on your network. Do not assign the same IP address to more than one computer and your CPE must be on the same subnet as all the other computers. The apply button will temporarily save this connection. To make the change permanent you need to click on Tools (at the top of the page) and select System Commands. At the system commands page, click on Save All. 4.5.2 Changing the CPEs IP address You can change the CPE's IP address by going to the Home screen, click setup and under LAN Setup, select Management. This will bring up the screen shown in Figure 11. 4.5.2.1 Static IP address assignment Your CPE's default IP address and subnet mask are 192.168.1.1/255.255.255.0; this subnet mask will allow the CPE to support 254 users. If you want to support a larger number of users you can change the subnet mask; but remember. The DHCP server is defaulted to only give out 255 IP addresses. Further remember that if you change your CPEs' IP address and you have DHCP enabled, the DHCP configuration must reside within the same subnet The default CPE is the routing device used to forward all traffic that is not addressed to a station within the local subnet. Your ISP will provide you with the default CPE Address. Figure 11 shows a default CPE address of 192.168.1.1 because this was the default CPE defined when the CLIP connection was configured. The hostname can be any alphanumeric word that does not contain spaces. The domain name is used to in conjunction with the host name to uniquely identify the CPE. To access the CPE's web pages the user can type 192.168.1.1 (the CPE's default IP address) or type mygateway. 21 21