Asus CUSI-M CUSI-M User Manual - Page 38

3. H/W SETUP Connectors 01 01 3. HARDWARE SETUP 27) ATX Power Supply Connector (20-pin block ATXPWR) This connector connects to an ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned. IMPORTANT: Make sure that your ATX power supply (minimum recommended wattage: 200 watts; 235W for a fully-configured system) can supply at least 20 amperes on the +5-volt lead and at least 10mA (750mA recommended) on the +5volt standby lead (+5VSB). Your system may become unstable/unreliable and may experience difficulty in powering up if your power supply is inadequate. For WakeOn-LAN support, your ATX power supply must supply at least 750mA +5VSB. ® CUSI-M CUSI-M ATX Power Connector +12.0 Volts +5V Standby Power Good Ground +5.0 Volts Ground +5.0 Volts Ground +3.3 Volts +3.3 Volts +5.0 Volts +5.0 Volts NC Ground Ground Ground Power Supply On Ground -12.0 Volts +3.3 Volts 28) Power Supply Thermal Sensor Connector (2-pin PWRTMP) If you have a power supply with thermal monitoring, connect its thermal sensor cable to this connector. PWRTMP Power Supply Thermal Sensor ® CUSI-M CUSI-M Thermal Sensor Connector 38 ASUS CUSI-M User's Manual