Asus CUV266 CUV266 User Manual - Page 37
CPU Fan, Power Fan, and Chassis Fan Connectors
View all Asus CUV266 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
3. HARDWARE SETUP 6) CPU Fan, Power Fan, and Chassis Fan Connectors (CPU_FAN, PWR_FAN, CHA_FAN) The three fan connectors support cooling fans of 350mA (4.2 Watts) or less. Orient the fans so that the heat sink fins allow airflow to go across the onboard heat sinks instead of the expansion slots. The fan wiring and plug may vary depending on the fan manufacturer. Connect the fan cable to the connector making sure that the black wire matches the ground pin. (NOTE: Use the "Rotation" signal only with a specially designed fan with a rotation signal. You can monitor the Rotations Per Minute (RPM) using ASUS PC Probe (see 6. SOFTWARE REFERENCE). WARNING! Make sure to connect the fan cables to the fan connectors. Lack of sufficient airflow within the system could cause damage to the motherboard. These are not jumpers, do not place jumper caps over these connectors! GND +12V Rotation CUV266 PWR_FAN CHA_FAN 01 01 01 3. H/W SETUP Connectors GND +12V Rotation GND +12V Rotation CPU_FAN CUV266 12-Volt Cooling Fan Power 7) USB Headers (10-1 pin USB2_3, USB4_5) If the USB port connectors on the back panel are inadequate, two USB headers are available for four additional USB port connectors. Connect a 2-port USB connector set to a USB header and mount the USB bracket to an open slot in the chassis. (The USB connector set is optional and does not come with the motherboard package.) CUV266 USB2_3 USB4_5 01 01 01 USB Power USBP2- USBP2+ GND NC 1 5 6 10 USB Power USBP3- USBP3+ GND CUV266 Front Panel USB Headers ASUS CUV266 User's Manual 37