Asus ESC2000 User Guide - Page 43
SATA backplane connections, Each SATA connector is labeled HDD1, HDD2
View all Asus ESC2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
2.9.2 SATA backplane connections An SATA backplane comes pre-installed in the ESC2000 G2. The SATA backplane has four 22-pin SATA connectors to support Serial ATA hard disk drives. The backplane design incorporates a hot swap feature to allow easy connection or removal of SATA hard disks. The LEDs on the backplane connect to the front panel LEDs to indicate HDD status. See section 1.7 LED information for details. Front side The front side of the SATA backplane faces the front panel when installed. This side includes four SATA connectors for the hot swap drive trays. HDD1 HDD2 HDD3 Drive status LEDs HDD4 Each SATA connector is labeled (HDD1, HDD2, HDD3, HDD4) so you can easily determine their counterpart connectors at the back side of the backplane. Refer to the table for reference. HDD Device HDD 1 HDD 2 HDD 3 HDD 4 Front side connector HDD1 HDD2 HDD3 HDD4 Back side connector CON1 CON2 CON3 CON4 ASUS ESC2000 G2 2-23