Asus M2N68-AM SE User Manual - Page 30

Open Network., Enable, Setup

Get Asus M2N68-AM SE PDF manuals and user guides View all Asus M2N68-AM SE manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

2. Open Network. Network 3. Make the proper network configurations. Each network interface is enabled immediately after you tick the Enable checkbox. • If you use a network cable connected to a home router that is connected to your DSL/ cable modem, enable all the LAN ports. Express Gate automatically uses the available port. • The number of the LAN ports vary with the motherboard. • If you plug the network cable into a different port while Express Gate is running (e.g. move the cable from LAN1 to LAN2), press the Refresh button to activate the new setting. • If your computer does not automatically get network settings from a DHCP server, click Setup to configure the static IP settings manually. If your computer automatically gets network settings from a DHCP server, skip this step. 1-21 Chapter 1: Product introduction

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
2.
Open Network.
3.
Make the proper network configurations.
Each network interface is enabled immediately after you tick the
Enable
checkbox.
Network
•
If you use a network cable connected to a home router that is connected to your DSL/
cable modem, enable all the LAN ports. Express Gate automatically uses the available
port.
•
If your computer does not automatically get network settings from a DHCP server, click
Setup
to configure the static IP settings manually. If your computer automatically gets
network settings from a DHCP server, skip this step.
•
The number of the LAN ports vary with the motherboard.
•
If you plug the network cable into a different port while Express Gate is running (e.g.
move the cable from LAN1 to LAN2), press the
Refresh
button to activate the new
setting.
Chapter 1: Product introduction
1-21