Asus P2L97 P2L97 User Manual - Page 11
ASUS P2L97 User's Manual, Jumpers, Expansion Slots/Sockets, Hardwar, e Monitor, Connectors - memory
View all Asus P2L97 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
III. INSTALLATION (Board Layout) III. INSTALLATION Jumpers 1) CLRTC 2) KB_UP 3) FS0, FS1, FS2 4) BF0, BF1, BF2, BF3 p. 13 Real Time Clock (RTC) RAM (Short/Clear CMOS) p. 13 Keyboard Power Up p. 14 CPU External Clock (BUS) Frequency Selection p. 14 CPU"BUS Frequency Ratio Expansion Slots/Sockets 1) System Memory p. 15 System Memory Support 2) DIMM Sockets p. 16 DIMM Memory Module Support 3) SEC CPU Slot p. 19 Single Edge Contact CPU Support 4) SLOT1, SLOT2 p. 24 16-bit ISA Bus Expansion Slots* 5) PCI1, 2, 3, 4, 5 p. 24 32-bit PCI Bus Expansion Slots 6) AGP p. 25 Accelerated Graphics Port Hardware Monitor 1) JP1 p. 22 Pentium II Processor Thermal Sensor Connector Connectors 1) PS2KEYBOARD p. 26 PS/2 Keyboard Connector (6-pin female) 2) PS2MOUSE p. 26 PS/2 Mouse Connector (6-pin female) 3) PRINTER p. 27 Parallel (Printer) Port Connector (25-pin female) 4) COM1, COM2 p. 27 Serial Port COM1 & COM2 (two 9-pin male) 5) FLOPPY p. 27 Floppy Drive Connector (34-pin block) 6) USB p. 28 Universal Serial BUS Ports 1 & 2 (two 4-pin female) 7) Primary / Second IDE p. 28 Primary / Secondary IDE Connector (40-pin blocks) 8) IDELED p. 29 IDE LED Activity Light (2 pins) 9) CHA_, PWR_, CPU_FAN p. 29 Chassis, Power Supply, CPU Fan Power Lead (3-pin block) 10) IR p. 30 Infrared Port Module Connector (5 pins) 11) ATXPWR p. 30 ATX Motherboard Power Connector (20-pin block) 12) WOL p. 31 Wake on LAN Connector (3 pins) (Reserved) 13) MSG LED (PANEL) p. 32 System Message LED (2 pins) 14) SMI (PANEL) p. 32 SMI Switch Lead (2 pins) 15) PWR SW (PANEL) p. 32 ATX Power & Soft-Off Switch Lead (2 pins) 16) RESET (PANEL) p. 32 Reset Switch Lead (2 pins) 17) PWR LED (PANEL) p. 32 System Power LED Lead (3 pins) 18) KEYLOCK (PANEL) p. 32 Keyboard Lock Switch Lead (2 pins) 19) SPEAKER (PANEL) p. 32 Speaker Output Connector (4 pins) *The onboard hardware monitor uses the address 290H-297H so legacy ISA cards must not use this address otherwise conflicts will occur. ASUS P2L97 User's Manual 11