Asus P2L97 P2L97 User Manual - Page 20
Installing the Processor - pentium 3
View all Asus P2L97 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
III. INSTALLATION CPU III. INSTALLATION Installing the Processor 1. Unlock the URM's Folding Support Arms: The folding support arms of the URM are locked when shipped. To unlock the support arms, simply flip them up to an upright position. Locked Folding Support Arms The URM is now ready for the installation of your processor. Unlocked Folding Support Arms 2. Attach the Heatsink NOTE: Follow carefully the heatsink attachment instructions included with your heatsink or processor. The following steps are provided only as a general guide and may not reflect those for your heatsink. SECC with Pentium® II Place the SECC face down on a flat surface Push each end of the clamps until they lock and lay the heat sink flush on the back (metal Lock Lock side) of the SECC. Check the orientation of the heatsink against the illustration below. The thicker fin must be orientated toward the bottom. The top clamp is wider than the bottom clamp so only this orientation will fit. With a screw driver, push the clamps one at a time into the SECC. Be sure that the heatsink is firmly pressed against the SECC. SECC2 with Pentium® II/SEPP with Celeron™ Insert the heatsink clip through the holes at the SECC2/SEPP's back, making sure that the bottom of the clip plate sits against the processors's back. Remove the tab from the thermal grease, SECC2/SEPP Heatsink Clip Legs which is located on the bottom of the heatsink) and place the heatsink over the processor. A slight rocking motion may be necessary to place the heatsink on the SECC2/SEPP, with one pair of the heatsink clip legs going first through the corresponding heatsink holes, and then the other pair. (NOTE: The heatsink and SECC2/SEPP holes are slightly offset to ensure good locking grip between the two.) 20 ASUS P2L97 User's Manual