Asus P2L97 P2L97 User Manual - Page 29
Chassis , CPU , & Power Supply Fan Connectors 3-pin FANPWR
View all Asus P2L97 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Rotation +12V GND III. INSTALLATION (Connectors) R R III. INSTALLATION 8. IDE activity LED (2-pin IDE_LED) This connector supplies power to the cabinet's IDE activity LED. Read and write activity by devices connected to the Primary or Secondary IDE connectors will cause the LED to light up. TIP: If the case-mounted LED does not light, try reversing the 2-pin plug. IDE_LED P2L97 IDE Activity LED 9. Chassis , CPU , & Power Supply Fan Connectors (3-pin FANPWR) These connectors support cooling fans of 500mAMP (6WATT) or less. Orientate the fans so that the heat sink fins allow airflow to go across the onboard heat sink(s) instead of the expansion slots. Depending on the fan manufacturer, the wiring and plug may be different. The red wire should be positive, while the black should be ground. Connect the fan's plug to the board taking into consideration the polarity of the this connector. NOTE: The "Rotation" signal is to be used only by a specially designed fan with rotation signal. WARNING! The CPU and/or motherboard will overheat if there is no airflow across the CPU and onboard heatsinks. Damage may occur to the motherboard and/or the CPU fan if these pins are incorrectly used. These are not jumpers, do not place jumper caps over these pins. Chassis Fan Power CPU Fan Power Power Supply Fan P2L97 12Volt Cooling Fan Power ASUS P2L97 User's Manual 29