Asus P5E-VM DO User Manual - Page 47
CPU, chassis, and power fan connectors, pin CPU_FAN, 3-pin CHA_FAN1, 3-pin PWR_FAN, Chassis
View all Asus P5E-VM DO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
8. CPU, chassis, and power fan connectors (4-pin CPU_FAN, 3-pin CHA_FAN1, 3-pin PWR_FAN) The fan connectors support cooling fans of 350 mA ~ 2000 mA (24 W max.) or a total of 1 A ~ 7 A (84 W max.) at +12V. Connect the fan cables to the fan connectors on the motherboard, making sure that the black wire of each cable matches the ground pin of the connector. Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside the system may damage the motherboard components. These are not jumpers! Do not place jumper caps on the fan connectors! P5E-VM DO R Rotation +12V GND CPU_FAN CPU FAN PWM CPU FAN IN CPU FAN PWR GND CHA_FAN1 PWR_FAN GND +12V Rotation P5E-VM DO Fan connectors Only the 4-pin CPU_FAN connectors support the ASUS Advanced Q-Fan feature. This motherboard does not support 3-pin CPU fan. 9. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default , the pin labeled "Chassis Signal" and " Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. P5E-VM DO R CHASSIS GND Chassis Signal (Default) +5VSB_MB P5E-VM DO Chassis Intrusion connector ASUS P5E-VM DO 1-35