Asus P5WD2 Motherboard Installation Guide - Page 58
P5WD2 Chassis intrusion connector, P5WD2 COM port connector
View all Asus P5WD2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
9. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. P5WD2 +5VSB_MB Chassis Signal GND ® CHASSIS (Default) P5WD2 Chassis intrusion connector 10. Serial port connector (10-1 pin COM1) This connector is for a serial (COM) port. Connect the serial port module cable to this connector, then install the module to a slot opening at the back of the system chassis. P5WD2 PIN 1 ® COM1 P5WD2 COM port connector 2-34 Chapter 2: Hardware information