Home » Asus Manuals » Motherboards » Asus RAMPAGE III GENE » Manual Viewer

Asus RAMPAGE III GENE Rampage III Gene User's Manual - Page 8

ご注意

View all Asus RAMPAGE III GENE manuals

Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

ご注意 Federal Communications Commission Statemen（t 原文） This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with manufacturer's instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Canadian Department of Communications Statemen（t 原文） This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This class B digital apparatus complies with Canadian ICES-003. REACH（原文） Complying with the REACH (Registration, Evaluation, Authorization, and Restriction of Chemicals) regulatory framework, we published the chemical substances in our products at ASUS website at http://green.asus.com/english/REACH.htm. viii

Section	Page
もくじ	3
ご注意	8
安全上のご注意	9
このマニュアルについて	10
Rampage III GENE 仕様一覧	12
Chapter 1: 製品の概要	15
1.1 ようこそ	17
1.2 パッケージの内容	17
1.3 独自機能	18
1.3.1 製品の特長	18
1.3.2 ROGインテリジェントパフォーマンス&オーバークロック機能	19
1.3.3 ROGだけの機能	20
1.3.4 ASUSの特別な機能	21
Chapter 2: ハードウェア	23
2.1 始める前に	25
2.2 マザーボードの概要	31
2.2.1 マザーボードのレイアウト	31
2.2.2 レイアウトの内容	32
2.2.3 設置方向	33
2.2.4 ネジ穴	33
2.3 CPU	34
2.3.1 CPUを取り付ける	34
2.3.2 CPUにヒートシンクとファンを取り付ける	37
2.3.3 CPUからヒートシンクとファンを取り外す	38
2.4 システムメモリー	39
2.4.1 概要	39
2.4.2 メモリー構成	40
2.4.3 メモリーを取り付ける	46
2.4.4 メモリーを取り外す	46
2.5 拡張スロット	47
2.5.1 拡張カードを取り付ける	47
2.5.2 拡張カードを設定する	47
2.5.3 割り込み割り当て	48
2.5.4 PCI スロット	49
2.5.5 PCI Express x4 スロット	49
2.5.6 PCI Express 2.0 x16 スロット	49
2.6 ジャンパ	51
2.7 コネクター	53
2.7.1 バックパネルコネクター	53
2.7.2 オーディオ I/O接続	54
2.7.3 内部コネクター	57
2.7.4 オンボードスイッチ	67
2.7.5 ProbeIt	69
2.8 初めて起動する	70
2.9 コンピューターをオフにする	71
2.9.1 OSシャットダウン機能を使用す	71
2.9.2 電源スイッチのデュアル機能を使用する	71
Chapter 3: BIOS Setup	73
3.1 BIOS 管理更新	75
3.1.1 ASUS Update	75
3.1.2 ASUS EZ Flash 2	78
3.1.3 ASUS CrashFree BIOS 3	79
3.2 BIOS Setup プログラム	80
3.2.1 BIOSメニュー画面	81
3.2.2 メニューバー	81
3.2.3 ナビゲーションキー	81
3.2.4 メニュー	82
3.2.5 サブメニュー	82
3.2.6 構成フィールド	82
3.2.7 ポップアップウィンドウ	82
3.2.8 スクロールバー	82
3.2.9 ヘルプ	82
3.3 Extreme Tweaker メニュー	83
3.3.1 Tuning Mode [Extreme OC]	84
3.3.2 CPU Level Up [Auto]	84
3.3.3 Ai Overclock Tuner [Auto]	84
3.3.4 CPU Ratio Setting [Auto]	85
3.3.5 CPU Turbo Power Limit [Enabled]	85
3.3.6 CPU Configuration	85
3.3.7 BCLK Frequency [XXX]	85
3.3.8 PCIE Frequency [XXX]	85
3.3.9 DRAM Frequency [Auto]	85
3.3.10 UCLK Frequency [Auto]	85
3.3.11 QPI Link Data Rate [Auto]	86
3.3.12 Memory Configuration Protect [Disabled]	86
3.3.13 DRAM Timing Control	86
3.3.14 EPU II Phase Control [Full Phase]	88
3.3.15 CPU Load-Line Calibration [Auto]	88
3.3.16 CPU Differential Amplitude [Auto]	88
3.3.17 IOH Voltage OCP [Enabled]	88
3.3.18 DRAM Voltage OCP [Enabled]	88
3.3.19 QPI Voltage OCP [Enabled]	88
3.3.20 Extreme OV [Disabled]	88
3.3.21 CPU Voltage Control [Absolute (VID)]	89
3.3.22 CPU Voltage [Auto]	89
3.3.23 CPU PLL Voltage [Auto]	89
3.3.24 QPI/DRAM Core Voltage [Auto]	89
3.3.25 IOH Voltage [Auto]	89
3.3.26 IOH PCIE Voltage [Auto]	89
3.3.27 ICH Voltage [Auto]	89
3.3.28 ICH PCIE Voltage [Auto]	89
3.3.29 DRAM Bus Voltage [Auto]	90
3.3.30 DRAM REF Voltages	90
3.3.31 CPU Spread Spectrum [Auto]	90
3.3.32 PCIE Spread Spectrum [Auto]	90
3.3.33 CPU Clock Skew [Auto]	90
3.3.34 IOH Clock Skew [Auto]	90
3.4 メインメニュー	91
3.4.1 System Time [xx:xx:xx]	91
3.4.2 System Date [Day xx/xx/xxxx]	91
3.4.3 Language [English]	91
3.4.4 SATA 1–6	92
3.4.5 記憶装置の設定	94
3.4.6 AHCI Configuration	95
3.4.7 システム情報	96
3.5 拡張メニュー	97
3.5.1 CPUの設定	97
3.5.2 チップセット	100
3.5.3 オンボードデバイス設定構成	101
3.5.4 USB設定	103
3.5.5 PCIPnP	104
3.5.6 LED Control	105
3.5.7 iROG Configuration	106
3.5.8 ROG Connect	107
3.6 電源メニュー	108
3.6.1 Suspend Mode [Auto]	108
3.6.2 Repost Video on S3 Resume [No]	108
3.6.3 ACPI 2.0 Support [Disabled]	108
3.6.4 ACPI APIC Support [Enabled]	109
3.6.5 EuP Ready [Disabled]	109
3.6.6 APMの設定	109
3.6.7 ハードウェアモニター	111
3.7 ブートメニュー	114
3.7.1 ブートデバイスの優先順位	114
3.7.2 起動設定	115
3.7.3 セキュリティ	116
3.8 ツールメニュー	118
3.8.1 ASUS EZ Flash 2	118
3.8.2 ASUS O.C. Profile	119
3.8.3 GO_Button File	121
3.8.4 Drive Xpert Configuration	122
3.9 終了メニュー	123
Chapter 4: ソフトウェア	125
4.1 OSをインストールする	127
4.2 サポートDVD情報	127
4.2.1 サポートDVDを実行する	127
4.2.2 ドライバーメニュー	128
4.2.3 ユーティリティメニュー	129
4.2.4 Make disk メニュー	130
4.2.5 マニュアルメニュー	130
4.2.6 ビデオメニュー	131
4.2.7 コンタクトインフォメーション	131
4.2.8 その他の情報	132
4.3 ソフトウェア情報	134
4.3.1 ASUS AI Suite II	134
4.3.2 TurboV EVO	135
4.3.3 FAN Xpert	137
4.3.4 Probe II	138
4.3.5 Sensor Recorder	140
4.3.6 Sound Blaster X-Fi	141
4.4 RAID	144
4.4.1 RAID の定義	144
4.4.2 Serial ATAハードディスクを取り付ける	145
4.4.3 BIOSでRAIDを設定する	145
4.4.4 Intel® Matrix Storage Manager option ROMユーティリティ	146
4.5 RAIDドライバーディスクを作成す	151
4.5.1 OSに入らずにRAIDドライバーディスクを作成する	151
4.5.2 RAIDドライバーディスクを Windows® 環境で作成する	151
Chapter 5: マルチGPUテクノロジサポート	153
5.1 ATI® CrossFireX™ テクノロジ	155
5.1.1 必要条件	155
5.1.2 始める前に	155
5.1.3 CrossFireX™ ビデオカードを取り付ける	156
5.1.4 デバイスドライバーをインストールする	157
5.1.5 ATI® CrossFireX™ テクノロジを有効にする	157
5.2 NVIDIA® SLI™ テクノロジ	159
5.2.1 必要条件	159
5.2.2 SLI対応ビデオカードを２枚取り付ける	159
5.2.3 デバイスドライバーをインストールする	160

Match case Limit results 1 per page

viii

ご注意

Federal Communications Commission Statement

（原文）

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

•

This device may not cause harmful interference, and

•

This device must accept any interference received including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with manufacturer’s instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment oﬀ and on,

the user is encouraged to try to correct the interference by one or more of the following

measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment to an outlet on a circuit diﬀerent from that to which the

receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Canadian Department of Communications Statement

（原文）

This digital apparatus does not exceed the Class B limits for radio noise emissions from

digital apparatus set out in the Radio Interference Regulations of the Canadian Department

of Communications.

This class B digital apparatus complies with Canadian ICES-003.

The use of shielded cables for connection of the monitor to the graphics card is required

to assure compliance with FCC regulations. Changes or modiﬁcations to this unit not

expressly approved by the party responsible for compliance could void the user’s authority

to operate this equipment.

REACH（原文）

Complying with the REACH (Registration, Evaluation, Authorization, and Restriction of

Chemicals) regulatory framework, we published the chemical substances in our products at

ASUS website at http://green.asus.com/english/REACH.htm.