Asus RS700-E8-RS8 User Guide - Page 32
Hard disk drives, To install a hot-swap SATA/SAS HDD
![]() |
View all Asus RS700-E8-RS8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
2.4 Hard disk drives The system supports eight (8) 2.5-inch hot-swap SATA/SAS hard disk drives. The hard disk drive installed on the drive tray connects to the motherboard SATA/SAS ports via the SATA/ SAS backplane. To install a hot-swap SATA/SAS HDD: 1. Push the spring lock to the right (A) then pull the tray lever outward (B) to release the drive tray. The drive tray ejects slightly after you pull out the lever. tray lever 2. Firmly hold the tray lever and pull the drive tray out of the bay. 3. Place the drive tray on a flat and stable surface. 4. Release the two screws then remove support beam from the drive tray. 5. Prepare the SATA/SAS HDD and the bundled set of screws. spring lock support beam 2-14 Chapter 2: Hardware setup
![](/manual_guide/products/asus-rs700e8rs8-user-guide-b2e6433/32.png)
Chapter 2:
Hardware setup
2-14
2.4
Hard disk drives
The system supports eight (8) 2.5-inch hot-swap SATA/SAS hard disk drives. The hard disk
drive installed on the drive tray connects to the motherboard SATA/SAS ports via the SATA/
SAS backplane.
To install a hot-swap SATA/SAS HDD:
1.
Push the spring lock to the right (A) then pull the tray lever outward (B) to release the
drive tray. The drive tray ejects slightly after you pull out the lever.
2.
Firmly hold the tray lever and pull the
drive tray out of the bay.
3.
Place the drive tray on a flat and
stable surface.
4.
Release the two screws then remove
support beam from the drive tray.
5.
Prepare the SATA/SAS HDD and the
bundled set of screws.
spring lock
support beam
tray lever