Asus V2-P5G965 User Manual - Page 62
JMicron JMB363® Serial ATA RAID connector 7-pin SATA
View all Asus V2-P5G965 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
11. JMicron JMB363® Serial ATA RAID connector (7-pin SATA_ RAID) This connector is for a Serial ATA signal cable. This connector supports a Serial ATA hard disk drive that you can configure for RAID through the onboard Serial ATA RAID controller. The JMicron controller mode item in the BIOS is set to [AHCI] by default, allowing you to use the connectors to build a RAID set. See section "5.4.5 Onboard Device Configuration" for details. P5B-VM R SATA_RAID1 GND RSATA _RXN1 RSATA _RXP1 GND RSATA _TXN1 RSATA _TXP1 GND SATA RAID Connector Before creating a RAID set using Serial ATA hard disks, make sure that you have connected the Serial ATA signal cables and installed Serial ATA hard disk drives; otherwise, you cannot enter the JMicron® JMB363 RAID utility and SATA BIOS setup during POST. 12. Serial port connector (10-1 pin COM1) This connector is for a serial (COM) port. Connect the serial port module cable to this connector, then install the module to a slot opening at the back of the system chassis. COM1 PIN 1 COM Port Connector The COM module is purchased separately. P5B-VM R 4-12 Chapter 4: Motherboard info