Avanti DG201BS Instruction Manual - Page 15
Maintenance, Warning
View all Avanti DG201BS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
CARE & MAINTENANCE Figure 18 A WARNING Electrical Shock Hazard Plug into a grounded 3-prong outlet. Do not remove ground prong. Do not use an adapter. Failure to follow these instructions can result in death, fire, or electrical shock. Figure 19 3-prong polarized ground-type outlet 1 11 S ground prong GENERAL RECOMANDATION Important: Before any operation of cleaning and maintenance disconnect the appliance from the electrical supply. It is advisable to clean when the appliance is cold and especially for cleaning the enamelled parts. Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces. Avoid using cleaning products with a chlorine or acidic base. The oven must always be cleaned after every use, using suitable products and keeping in mind that its operation for 33 minutes on the highest temperature eliminates most grime reducing it to ashes. ENAMELLED PARTS All the enamelled parts must be cleaned with a sponge and soapy water only or other non-abrasive products. Dry preferably with a chamois leather. If acid substances such as lemon juice, tomato conserve, vinegar etc. are left on the enamel for a long time they will etch it, making it opaque. STAINLESS STEEL ELEMENTS Stainless steel parts must be rinsed with water and dried with a soft and clean cloth or with a chamois leather. For difficult dirt, use a specific non-abrasive product available commercially or a little hot vinegar. Note: regular use could cause discolouring around the burners, because of the high flame temperature. INSIDE OF OVEN This must be cleaned regularly. With the oven warm, wipe the inside walls with a cloth soaked in very hot soapy water or another suitable product. WARNING VERY IMPORTANT Before any operation of maintenance disconnect the appliance from the electrical mains supply. Do not use steam jet cleaners because the humidity could infiltrate into the appliance making S. it dangerous GAS VALVES In the event of operating faults in the gas valves, call the Service Department. REPLACING THE OVEN LIGHT Before any maintenance is started involving electrical parts of the appliance, it must be disconnected from the power supply. - Let the oven cavity and the broil burner cool down; - Switch off the electrical supply; - Remove the protective cover; - Unscrew and replace the bulb with a new one suitable for high temperatures (300°C- 570°F) having the following specifications: 120V 60 Hz, 15W, E14 Refit the protective cover. NOTE: Oven bulb replacement is not covered by your guarantee. 15