Avanti DG202BS Instruction Manual - Page 15

CARE & MAINTENANCE GENERAL RECOMANDATION ‡ Important: Before any operation of cleaning and maintenance disconnect the appliance from the electrical supply. ‡ It is advisable to clean when the appliance is cold and especially for cleaning the enamelled parts. ‡ Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces. ‡ Avoid using cleaning products with a chlorine or acidic base. The oven must always be cleaned after every use, using suitable products and keeping in mind that its operation for 30 minutes on the highest temperature eliminates most grime reducing it to ashes. WARNING When correctly installed, your product meets all safety requirements laid down for this type of product category. However special care should be taken around the rear or the underneath of the appliance as these areas are not designed or intended to be touched and may contain sharp or rough edges, that may cause injury. ENAMELLED PARTS ‡ All the enamelled parts must be cleaned with a sponge and soapy water only or other non-abrasive products. ‡ Dry preferably with a soft cloth. If acid substances such as lemon juice, tomato conserve, vinegar etc. are left on the enamel for a long time they will etch it, making it opaque. Figure 16 WARNING Electrical Shock Hazard Plug into a grounded 3-prong outlet. Do not remove ground prong. Do not use an adapter. Failure to follow these instructions can result in death, fire, or electrical shock. Figure 17 3-prong polarized ground-type outlet STAINLESS STEEL ELEMENTS ‡ Stainless steel parts must be rinsed with water and dried with a soft and clean cloth or with a chamois leather. ‡ For difficult dirt, use a specific non-abrasive product available commercially or a little hot vinegar. ‡ Note: regular use could cause discolouring around the burners, because of the high flame temperature. ground prong INSIDE OF OVEN This must be cleaned regularly. With the oven warm, wipe the inside walls with a cloth soaked in very hot soapy water or another suitable product. GAS VALVES In the event of operating faults in the gas valves, call the Service Department. REPLACING THE OVEN LIGHT Before any maintenance is started involving electrical parts of the appliance, it must be disconnected from the power supply. - Let the oven cavity and the broil burner cool down; - Switch off the electrical supply; - Remove the protective cover; - Unscrew and replace the bulb with a new one suitable for high temperatures (300°C- 570°F) having the following specifications: 120V 60 Hz, E14 - Refit the protective cover. NOTE: Oven bulb replacement is not covered by your guarantee. WARNING VERY IMPORTANT Before any operation of maintenance disconnect the appliance from the electrical mains supply. Do not use steam jet cleaners because the humidity could infiltrate into the appliance making it dangerous. 15