Behringer SHARK FBQ100 Manual - Page 10

10

SHARK FBQ100 User Manual

Strain relief clamp

Sleeve

Tip

Sleeve

(ground/shield)

Unbalanced ¼" TS connector

Tip

(signal)

output

For unbalanced use, pin 1 and pin 3 have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

input

1

2

3

1

2

3

Balanced use with XLR connectors

Fig. 3.2: Different plug types

Please ensure that only qualified persons install and operate the

◊

SHARK. During installation and operation the user must have sufficient

electrical contact to earth. Electrostatic charges might affect the

operation of the SHARK!

strain relief clamp

sleeve

ring

tip

sleeve

ground/shield

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

Balanced ¼" TRS connector

ring

cold (-ve)

tip

hot (+ve)

Section	Page
Thank you	2
Important Safety Instructions	3
Legal Disclaimer	3
Limited Warranty	3
1. Introduction	5
1.1 The concept	5
1.2 Before you begin	5
1.3 Control elements	5
2. Applications	7
2.1 Wiring the FBQ100: general remarks	7
2.1.1 Connection between microphone and mixing console	7
2.1.2 Connection between line-level source and mixing console	7
2.1.3 Connection between mixing console and power amplifier	7
2.1.4 The SHARK used in the monitor path	7
2.1.5 The SHARK used in single channels and subgroups	8
2.1.6 Automatic “tuning in” of P.A. and monitor systems	8
2.2 The feedback destroyer in the SHARK	8
2.3 The integrated delay	8
2.4 The noise gate function	9
2.5 The low cut filter in the SHARK	9
2.6 The compressor function	9
3. Installation	9
3.1 Audio connections	9
4. Specifications	11

Behringer SHARK FBQ100 Manual - Page 10

electrical contact to earth. Electrostatic charges might aﬀect

Page 10 highlights