Beko DIN14C10 User Manual - Page 10
Connect²on to the dra²n, Electr²cal connect²on, Adjust²ng the feet
View all Beko DIN14C10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installation Connection to the drain Water discharge hose can directly be connected to the drain hole or sink's drainage. The length of this connection must be min. 50 cm and max. 100 cm from the floor. A discharge hose longer than 4 meters will cause washing performance to be affected.Attach the water discharge hose to the drainpipe without bending it. Tightly fix the water discharge hose to the drainpipe in order to prevent any dislocation of the water discharge hose during operation of the product. Electrical connection Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating label corresponds to your electricity supply. We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket in a readily accessible position. If the supply cord or the mains lead is damaged please do not replace it yourself. The supply cord or the mains lead must be replaced by a Authorised Service Agent or a similarly qualified person. min 120 max 1000 min 500 min 300 C Drainpipe must be connected to the foul water system and it should not be connected to any surface water drain. Adjusting the feet If the door of the product cannot be closed properly or if the product wobbles when you push it slightly, then you need to adjust the feet of the product. Adjust the feet of the product as illustrated in the relevant section. 10 /35 EN Dishwasher / User's Manual