Beko DIN14C10 User Manual - Page 17

Preparation 2in1: Contains detergent, rinse aid or water 1. Open the lid of the rinse aid reservoir softening salt by pressing its latch (B). 3in1: Contains detergent, rinse aid and water softening salt 4in1: Contains glass protectors in addition to detergent, rinse aid and water softening salt 5in1: Contains glass and stainless steel protectors in addition to detergent, rinse aid and water softening salt C Observe the instructions of the detergent manufacturer on the package when using tablet B detergents. When you switch to powder detergent from tablet detergent: 1. Make sure that salt and rinse aid reservoirs are full. 2. Set the water hardness to the highest level and perform an empty run. 3. After the empty washing cycle, review the user manual and readjust the water hardness level so as to suit the water supply. 4. Make the appropriate rinse aid settings. C Depending on the model, salt indicator and/or rinse aid indicator must be enabled again if they were disabled before. 2. Fill the reservoir until "MAX" level. 3. Close the lid of the reservoir by pressing on it lightly. C Wipe clean any spilled rinse aid outside the reservoir. Rinse aid that spilled accidentally will cause foaming and it will eventually decBrease washing performance. 4 Rinse aid C The rinse aid used in dishwashers is a special combination used to increase drying efficiency and prevent water or limescale stains on the washed items. For this reason, care must be paid to have rinse aid in the rinse aid reservoir and to use rinse aids produced specially for dishwashers only. Dishwasher / User's Manual 4 4. Turn the rinse aid amount adjuster manually to a position between 1 and 6 (4). If there are stains on tableware items after washing, level must be 17/35 EN