Beko HII64500FHT User Manual - Page 23

Overheating protection Your hob is equipped with some sensors ensuring protection against overheating. Following may be observed in case of overheating: • Active cooking zone may be turned off. • Selected level may drop. However, this condition cannot be seen on the indicator. Overflow safety system Your hob is equipped with overflow safety system. If there is any overflow that spills onto the control panel, system will cut the power connection immediately and turn off your hob. "E" warning appears on display during this period. Precise power setting Induction hob reacts the commands immediately as a feature of its operating principles. It changes the power settings very fast. Thus, you can prevent a meal (water, milk) from overflowing even if it was just about to overflow. Operating noisy Some noises may arise from the induction hob. These sounds are normal and a part of induction cooking. • Noise becomes prominent in high temperature levels. • Alloy of the saucepan can cause noise. • In low levels, a regular on/off sound can be heard because of the operating principles. • Noise can be heard if an empty saucepan is heated. When you put water or meal in it, this sound will clear away. • The noise of the fan that cools electric system can be heard. Error codes / warning messages and error sources Table-2: Cause of error Two or more keys are pressed or overflow spills onto the keys. Hob overheated Indicator "E" symbol flashes "H" symbol flashes No proper vessel on the zone. Touch control hardware error, Induction hardware error. "I.:-1." symbol lights up "Fx**" symbol lights up "Ex**" symbol lights up Touch-key sensitivity error Communication error in touch control. Induction harcfAlare error. "F2" symbol lights up "F3" symbol lights up "Ex**" symbol flashes x**: "1,2,..,9" Display Cooking zone display Cooking zone display Cooking zone display Timer display Cooking zone display Timer display Timer display Cooking zone display For further information about error messages that may appear on the touch control panel, see Table-2. If "Fx" and "Ex" messages display constantly, call Authorized Service Agent. If the surface of the touch control panel is exposed to intense vapor, entire control system may become deactivated and give "E" error signal. Signal sounds are heard. Keep the surface of the touch control panel clean. Erroneous operation may be observed. 23/EN