Beko HQC64401 User Manual - Page 18

/ Display the remaining time value of the cooking zone unintentionally, the cooking zone will automatically be timer 3 (indicator LED flashes) to the timer display (the deactivated after a certain period of time. (see, Table- indicator LEDs of the active timers of the cooking 1). Operation time limit depends on the selected zones 1 and 4 in fact will not be visible on the timer temperature setting. If there is a timer assigned for the display). cooking zone, "00" appears on the timer display for Keep warm function (if any) 10 seconds (10 seconds later, residual heat indicator Keep Warm function of the cooking zone helps to keep turns on). the food warm by selecting an additional temperature 0" level between 0 and 1. Touch" key to activate the Keep Warm function. Then, " 0" LED flashes. Touch " 0" key again to disable the cooking zone. Then, timer display is turned off. After disabling the cooking zone automatically as described above, it becomes operational again and maximum operation time is applied for this temperature setting. Operation time constraints The hob control is equipped with an operation time limit. When one or more cooking zones are left on Table-1: Temperature setting parameters; Cycle time 47.0 seconds Temperature OFF Time - sec- ON Time - sec- Operation time Booster time - setting onds onds limit - hour seconds 0 0 0 0 45.6 1,4 6 60 2 43.6 3,4 6 180 3 41.3 5,7 5 288 4 38.4 8,6 5 390 5 35.9 11,1 4 510 6 33.1 13,9 1,5 150 7 26.2 20,8 1,5 210 8 19.2 27,8 1,5 270 9 0 47,0 1,5 Residual Heat Functions and ambient conditions. Do not cover the glass part of For a deactivated cooking zone whose surface tem- the sensor with anything during calibration. Hob perature is sensed to be above 60°C or whose display control system should also not be exposed to strong indicates a value above 60°C, a " AI " (residual heat) symbol appears on the display. When residual heat falls below 60°C, "0" appears on the display. When power restores after a power failure and if the residual heat of the relevant cooking zone was above 60°C before the failure, residual heat display flashes. Display continues to flash until the maximum residual heat time is over or the cooking zone is selected and enabled. light sources such as sun light, strong halogen lamps and etc. Table-2:Error codes and error sources Cause of error Display Ambient light is too high Fl Fluorescent lamp F2 Sensor is covered v!itli a bright sub- F3 stance Ambient light is fluctuating strongly F4 Sensor Calibration and Error Messages Sample application: When the supply power is applied, hob control system Following lightning conditions will allow a smooth performs calibration depending on the sensor, glass calibration: 1 8/EN