Beko WMB714422 User Manual - Page 39

5 Troubleshooting Problem Programme cannot be started or selected. Reason Solution The product may have switched to self protection ŠŠ Press and hold Start / Pause / Cancel mode due to a supply problem (line voltage, water button for 3 seconds to reset the pressure, etc.). product to factory settings. (See. Cancelling the programme") Water inside the product. The product does not take water in. The product does not drain water. Product vibrates or makes noise. There is water leaking from the bottom of the product. Product stopped shortly after the programme started. Product directly discharges the water it takes in. No water can be seen in the product during washing. Loading door cannot be opened. Some water might have remained in the product ŠŠThis is not a failure; water is not due to the quality control processes in the harmful to the product. production. Tap is turned off. ŠŠTurn on the taps. Water inlet hose is bent. ŠŠFlatten the hose. Water inlet filter is clogged. ŠŠClean the filter. Loading door may be open. ŠŠClose the door. Water drain hose might be clogged or twisted. ŠŠClean or flatten the hose. Pump filter is clogged. ŠŠ Clean the pump filter. Product might be standing unbalanced. ŠŠStable the product by adjusting the feet. A hard substance might have entered into the pump filter. ŠŠClean the pump filter. Transportation safety bolts are not removed. ŠŠRemove the transportation safety bolts. Laundry quantity in the product might be too little. ŠŠAdd more laundry to the product. Excessive laundry might be loaded in the product. ŠŠTake out some of the laundry from the product or distribute the load by hand to balance it homogenously in the product. Product might be leaning on a rigid item. ŠŠMake sure that the product is not leaning on anything. Water drain hose might be clogged or twisted. ŠŠClean or flatten the hose. Pump filter is clogged. ŠŠClean the pump filter. Machine might have stopped temporarily due to ŠŠProduct will resume running when the low voltage. voltage restores to the normal level. Draining hose might not be at adequate height. Water is inside the invisible part of the product. ŠŠConnect the water draining hose as described in the operation manual. ŠŠThis is not a failure. The cover lock is activated due to the water level ŠŠDrain the water by running the Pump inside the product. or Spin programme. Product is heating up the water or it is at the spinning cycle. ŠŠ Wait until the programme completes. Child lock is engaged. Door lock will be deactivated ŠŠWait for a couple of minutes for a couple of minutes after the programme has deactivation of the door lock. come to an end. 39 / EN Washing Machine / User's Manual