Beko WR862441 User Manual - Page 36

When draining of water is finished, close the end by the plug again and fix the hose

Get Beko WR862441 PDF manuals and user guides View all Beko WR862441 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

A CAUTION: Foreign substances left in the pump filter may damage your product or may cause noise problem. CAUTION: In regions where freezing is possible, the faucet must be closed, system hose must be removed and the water inside the product must be drained when the product is not in use. CAUTION: After each use, turn off the water tap to which the mains hose is connected. In order to clean the dirty filter and discharge the water: 1 Unplug the product to cut off the supply power. A CAUTION: Temperature of the water inside the product may rise up to 90 ºC. To avoid the burning risk, clean the filter after the water inside the product is cooled down. 2. Open the filter cover. 3 Follow the below procedures in order to drain water. If the product has an emergency water draining hose, in order to drain the water: a Pull the emergency draining hose out from its seat b Place a large container at the end of the hose. Drain the water into the container by pulling out the plug at the end of the hose. When the container is full, block the inlet of the hose by replacing the plug. After the container is emptied, repeat the above procedure to drain the water in the product completely. c When draining of water is finished, close the end by the plug again and fix the hose in its place. d Turn and remove the pump filter. 4 Clean any residues inside the filter as well as fibres, if any, around the pump impeller region. 5. Replace the filter. 6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat the tabs in the lower part into their places first, and then press the upper part to close. 36 / EN Washing Machine / User's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
36 / EN
Wash±ng Mach±ne / User’s Manual
A
CAUT±ON:
Foreign substances left in the pump filter may damage your product or may
cause noise problem.
CAUT±ON:
In regions where freezing is possible, the faucet must be closed, system hose
must be removed and the water inside the product must be drained when the product is not
in use.
CAUT±ON:
After each use, turn off the water tap to which the mains hose is connected.
±n order to clean the dIrty fIlter and dIscharge the water:
1 Unplug the product to cut off the supply power.
A
CAUT±ON:
Temperature of the water inside the product may rise up to 90 ºC. To avoid the
burning risk, clean the filter after the water inside the product is cooled down.
2. Open the filter cover.
3 Follow the below procedures in order to drain water.
±f the product has an emergency water draInIng hose, In order to draIn the water:
a
Pull the emergency draining hose out from its seat
b
Place a large container at the end of the hose. Drain the water into the container by
pulling out the plug at the end of the hose. When the container is full, block the inlet
of the hose by replacing the plug. After the container is emptied, repeat the above
procedure to drain the water in the product completely.
c
When draining of water is finished, close the end by the plug again and fix the hose in
its place.
d
Turn and remove the pump filter.
4 Clean any residues inside the filter as well as fibres, if any, around the pump impeller
region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If
it is one piece, seat the tabs in the lower part into their places first, and then press the
upper part to close.