Belkin F6C230-RKM-2U Belkin OmniGuard Rackmount UPS Hardware Manual - Page 14

MAINTENANCE OmniGuard TM Rackmount UPS Battery Replacement Instructions Important Please Read The Warnings And Instructions Before Attempting To Replace The Batteries: 1. Turn off all connected equipment that is plugged into the UPS 2. Press and release, after one beep, the ON/OFF button of the front panel 3. Remove the front Bezel of the UPS 4. Unplug the connected equipment form the UPS 5. Unplug the UPS's AC connection 6. Remove the four retaining screws form the bezel bracket 7. Using the pull-tab, pull the battery out on the left side of the UPS(if looking directly at the UPS). Do not pull the batteries out by the jumper cords. 8. Disconnect the positive (red) wire from the battery positive terminal 9. Remove the rest of the batteries, disconnect the battery jumper wires and the negative wire (black) from the battery's negative terminal 10. Reconnect the battery negative (black) wire to the negative terminal and the battery jumper wires. Verify proper polarity, negative (black) to the proper negative terminals and the battery jumper cables are connected properly. 11. Reinstall the batteries into the UPS, except for the battery on the left hand side of the UPS. Reconnect the battery positive (red) wire to the battery positive terminal. Verify proper polarity, reinstall the battery into the UPS 12. Reinstall the battery retaining bracket and the retaining screws 13. Reinstall the front bezel of the UPS 14. Dispose of the batteries properly at an appropriate recycling facility 26 OBTAINING SERVICE 1. Use the TROUBLESHOOTING section to eliminate obvious causes. 2. Verify there are no circuit breakers tripped. A tripped circuit breaker is the most common problem. 3. Please have the following information available BEFORE calling the Technical Support department. b) Your name and address. c) Where and when the unit was purchased. d) All of the model information on the rear panel of your UPS. e) Any information on the failure, including LEDs that may be illuminated. f) A description of the protected equipment, including model numbers, if possible. g) A technician will ask you for the above information and, if possible, help solve your problem over the phone. In the event that the unit requires factory service, the technician will issue you a Return Material Authorization Number (RMA #). h) If the UPS is under warranty, the repairs will be done at no charge. If not, there will be a charge for repair. Pack the UPS in its original packaging. If the original packaging is no longer available, ask the Technical Support technician about obtaining a new set. It is important to pack the UPS properly in order to avoid damage in transit. Never use Styrofoam beads for a packing material. Include a letter with your name, address, daytime phone number, RMA number, a copy of your original sales receipt, and a brief description of the problem. Mark the RMA # on the outside of all packages. The factory cannot accept any package without the RMA # marked on the outside. Tech Support Contact Information: Phone (800) 223-5546 x2263 or Phone (310) 898-1100 x2263 Fax (310) 604-2089 27