BenQ PH460 RS232 Commands for PDP and IFP Products - Page 14
Commercial Display RS-232 Protocol
View all BenQ PH460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ʳ ʳʳ ʳ ʳ ʳʳ ʳ Button&IR Control 8 ʳ g ʳ ʳʳ ʳ Video Source 8 ʳ g ʳ ʳ ʳʳ ʳ ʳ ʳʳ ʳ ʳʳ ʳ ʳ ʳʳ ʳ ʳ ʳʳ ʳ ʳ ʳ ʳʳ ʳ ʳ ʳʳ ʳ ʳ ʳʳ ʳ ʳʳ ʳ ʳʳ ʳʳ ʳ ʳʳ ʳʳ ʳ Power 8 ʳ g ʳ ʳʳ ʳ 5V 8 ʳ g 12V 8 ʳ g Ambient 10 ʳ g Sensor Value ʳ ʳ 69 ʳ 6A ʳ ʳ 6C ʳ 6D 6E 70 002: Passthrough Master Note: To set Pass through, the command must use the "With ID protocal", and the ID ʳ should between "01"~"98". 003: Passthrough Slave Note1: To set Pass through, the command must use the "With ID protocal", and the ID should between "01"~"98". Note2: The monitor will not response to any ʳ RS232 command if it is at Passthrough Slave mode 000: Disable 001: Enable 000 : VGA 001 : HDMI1 002: HDMI2 003 : AV 004 : YPbPr 005 : S-Video 006 : DVI 007 : DisplayPort 008 : SDI 009 : Multi-Media 010:Network 011: USB Display 000: Standby 001: On ~050 ~120 00000 ~ 2000 All the buttons at both keypad board and remote controller have no function. ʳ If PIP or PBP=On, the return value is the source at active window. ʳ Option, not support if the platform doesn't have this feature. Option, not support if the platform doesn't have this feature. ʳ Option, not support if the platform doesn't have this feature. ʳ ʳ Option, not support if the platform doesn't have this feature. Option, not support if the platform doesn't have this feature. Option, not support if the platform doesn't have this feature. Option, not support if the platform doesn't have this feature. ʳ ʳ value=049 means 4.9V value=122 means 12.2V Ex: If the value is 500, the return value should be: Byte1=0x30, Byte2=0x35, Byte3=0x30, Byte4=0x30, Byte5=0x30. V1.0 14 / 20 Commercial Display RS-232 Protocol