Bernina 730 Manual - Page 15
Bernina 730 Manual
View all Bernina 730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
14 35 37 36 39 II ig. 8 For winding the cover 14 is turned upwards and the lever 34 carrying the winding device is swivelled out towards backside onto the stop (fig. 8). A more perfect stitch is obtained if the under thread is chosen somewhat finer than the one used for upper thread. The reel from which the winding has to be done is placed onto one of the two reel-pins 35. In order to prevent the whole machine from running needlessly when winding, turn with your right hand the handwheel release screw 16 as far as possible towards you, at the same time holding the handwheel 34 15 firmly with your left hand. Place the bobbin 37 onto the bobbin shaft 36 pro- jecting from the hinged cover. The threading is done 15 as follows: First lead the thread from the reel to the winder pretension device 34, and from here around thread guide bolt 38 to the bobbin 37. The thread should wind in clockwise direction. Now push 16 lever 39 towards the bobbin until it gets engaged. Then the motor can be started by a slight pressure on the knee lever, respectively on the pedal starter, the mechanism being still at rest. Operate the machine until the bobbin is filled, whereupon the winder will stop automatically. When the filled bobbin has been taken off, lever 34 with winder pretension device has to be turned in and hinged cover 34 can be returned to its starting position. Tighten handwheel release screw 16 again. 13