Bernina 730 Manual - Page 56

At the left of the zigzag lever is placed the ornamental stitch selecting lever 12 which equally projects frcm plate 112. This plate bears the symbols of the twenty possible ornamental stitches to be sewn. When sewing zigzag stitches, lever 12 which shows a white line on its side facing the scale images, is set at zero, marked by a zigzag line, i.e. in front position. - If you have selected an ornamental stitch. set switching lever 12 against that symbol so that the white line thereon lines up with its mark. This is made in the following manner: Pull lever 12 to the right in its guiding slot and displacing it until its line and the stitch symbol line up. and then release. It will automatically be locked -at once and remain in this position. When displacing said lever make sure that the needle is outside the fabric, i.e. in its raised position. The stitch width adjusting knob 18 should be set in such a way as to show the number 4 in the sight opening. i.e. to produce the largest stitch width. After threading the machine, ornamental stitching can be started exactly in the same way with or-dinary sewing. When switching back to normal zigzag stitches, place switching lever 13 again in front position. Stitch width 4 Stitch length nearly zero Pattern no. l' 2' 3 4' 5 The fancy stitches of el. 731 are marked with an asterisk t"). Fig. "13 7 8 9 10' 11 12 13 14 15 10 17 18 19 21 11