Biostar IDEQ 220K BIOS MANUAL - Page 28
UR2 Duplex Mode, Onboard Parallel Port, Parallel Port Mode, ECP Mode Use DMA
View all Biostar IDEQ 220K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
K8VBK-S7 BIOS Setup 5.3.5 5.3.6 5.3.7 5.3.8 UR2 Duplex Mode Select the value required by the IR device connected to the IR port. Full-duplex mode permits simultaneous two-direction transmission. Half-duplex mode permits transmission in one direction only at a time. The Choices: Half (default), Full. Onboard Parallel Port This item allows you to determine access onboard parallel port controller with which I/O Address. The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled. Parallel Port Mode The default value is SPP. The Choices: SPP(default) Using Parallel port as Standard Printer Port. EPP Using Parallel Port as Enhanced Parallel Port. ECP Using Parallel port as Extended Capabilities Port. ECP+EPP Using Parallel port as ECP & EPP mode. ECP Mode Use DMA Select a DMA Channel for the port. The Choices: 3 (default), 1. 27