Bissell AeroSwift™ Compact Vacuum User's Guide - Page 7

Operations 5 Height Adjustments Turn the height adjustment dial on the front of the power foot to match your cleaning needs. The graphics around the dial indicate the appropriate setting for cleaning bare floor to high pile carpet. Turn the dial to the center for medium pile carpet. NOTE: If difficult to push, adjust to highest setting. Above Floor Cleaning Long Reach Cleaning Ideal for cleaning areas with 5- to 10-foot 1. required reach. 1. In upright position, lift the Quick Release Lever on the back of the vacuum to slide the Quick Release Handle out of the base. 2. Remove the hose from the hose wand base and connect to the open inlet at the handle. 3. Connect desired tool to the end of the wand 3a. for cleaning different above floor surfaces.  a. Extension Wand: connect with a desired tool for a farther reach.  b. Crevice Tool: use in tight, narrow spaces.  c. TurboBrush® Tool: use air-driven power brush to clean areas such as stairs, furniture, 3c. and other areas too small to clean in floor cleaning mode.  d. Combo Dusting/Upholstery Brush: use dusting brush to clean delicate surfaces; slide dusting brush off to clean upholstery and other hard surfaces. Short Reach Cleaning Ideal for cleaning areas with below 5-foot 4. required reach. 4. In upright position remove the hose from the hose wand base. 5. Attached desired tool to the end of the hose. 2. 3b. 3d. 5. NOTICE: The brush will continue to rotate at the same speed at all settings. NOTICE: Refer to maintenance section if you observe a loss in suction performance while in floor cleaning mode. www.bissell.com 800.237.7691 7