Bissell ICONpet Cordless Vacuum 22889 User Guide - Page 10

Warning, Notice

Page 10 highlights

Disposing of the Batteries Go to support.BISSELL.com for additional support and how-to videos. 1. Run the battery out. Make sure the unit is disconnected from the charger and turned OFF and the hand vacuum is disconnected from the extension wand. 2. Remove five screws from the 3. Pull the bottom cover off of back of the unit. the back of the unit. 4. Disconnect and remove entire battery assembly by unplugging the two sockets from the vacuum. 5. Properly discard remainder of product. NOTE: Keep Battery Pack together - DO NOT separate individual batteries. For specific disposal instructions of batteries, please contact the RBRC (Rechargeable Battery Recycling Corporation) at 1-800-822-8837 or visit www.call2recycle.org. NOTICE Disconnecting the battery will destroy the appliance and invalidate the warranty. WARNING This product contains lithium-ion rechargeable batteries. According to Federal and state regulations, removal and proper disposal of lithium-ion batteries is required. For removal of the batteries in your ICONpet Cordless, see instructions on this page. 10 BISSELL.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

10
BISSELL.com
Disposing of the Batteries
Go to
support.BISSELL.com
for additional support and how-to videos.
WARNING
This product contains lithium-ion rechargeable batteries. According to Federal and
state regulations, removal and proper disposal of lithium-ion batteries is required. For removal of the batteries in
your ICONpet Cordless, see instructions on this page.
NOTICE
Disconnecting the battery will destroy the appliance and invalidate the warranty.
NOTE:
Keep Battery Pack together – DO NOT separate individual batteries. For specific disposal instructions of batteries, please
contact the RBRC (Rechargeable Battery Recycling Corporation) at 1-800-822-8837 or visit www.call2recycle.org.
1.
Run the battery out. Make
sure the unit is disconnected
from the charger and turned
OFF and the hand vacuum
is disconnected from the
extension wand.
2.
Remove five screws from the
back of the unit.
3.
Pull the bottom cover off of
the back of the unit.
4.
Disconnect and remove
entire battery assembly by
unplugging the two sockets
from the vacuum.
5.
Properly discard remainder
of product.