Bissell ICONpet Cordless Vacuum 22889 User Guide - Page 9
Cleaning & Replacing the Filters
View all Bissell ICONpet Cordless Vacuum 22889 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Cleaning & Replacing the Filters Go to support.BISSELL.com for tips on maintaining and replacing your vacuum filters. Pre-Motor Filters For best cleaning performance, always clean your pre-motor filter after each use. 1. To clean the pre-motor filter, turn OFF machine and remove Dirt Tank from the hand vacuum. 2. Pull filter from the top of the tank. Remove the filter from the filter frame housing. Tap the filter against the side of a trash bin to remove dust and debris. 3. To clean, rinse under warm water and squeeze to remove dirt. Lay out for 24 hours, until completely dry. Make sure to replace your filter into the frame with the tag side down (touching the frame) before using your machine. Post-Motor Filter 1. To clean your post-motor filter, turn OFF machine and press the latch on the back of the hand vacuum. 2. Remove the post-motor filter from the vacuum. 3. If there's debris on the filter, tap it on a trash bin and rinse under warm water. Let dry for at least 24 hours before putting it back in the vacuum and replacing the filter cover. WARNING »»Do not use your vacuum until you are familiar with all instructions and operating procedures. »»Before using your vacuum, make sure that the Dirt Tank is in locked position and that all filters, both pre and post-filters, are in place. DO NOT operate your vacuum without these filters. BISSELL.com 9