Bissell ProHeat 2X Revolution Pet Pro Carpet Cleaner 1986 User Guide - English - Page 17

Cleaning Machine After Use WARNING To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. First, fill the clean water tank with warm tap water and then empty it all to rinse. Then fill again with warm tap water and return the tank to the machine. Twist cap back on tightly. To flush and rinse the machine: Turn the machine on and press the trigger for 15 seconds while making back and forth passes on a section of carpet. Finally, release the trigger and extract the water. See page 16 to clean the dirty tank from the water that was just extracted. Empty the clean water tank and let dry before storing. Wipe your machine's exterior with a soft cloth. Store machine in a protected dry area. Brush Roll & Nozzle Care NOTE: Be sure to clean the brush rolls and nozzle before storing your machine. Follow these steps if your nozzle becomes clogged with hair or debris. 1 2 Turn off and unplug the machine from the grounded outlet. Remove the nozzle from the foot: scoop and grip the Accessory Hose Door. Pull up to remove the nozzle. 3 Next, remove 4 the next layer, the brush roll cover, to reveal the brush rolls. Press on the two release buttons and lift straight up. At this point, the nozzle and brush roll cover can be rinsed under running water and the nozzle clean out tool can be inserted to unclog hair or debris. NOTICE: To reduce the risk of a leaking condition, do not store unit where freezing may occur. Damage to internal components may result. www.BISSELL.com 17