Bissell ProHeat Pet Deep Cleaning System 89104 User Guide - English - Page 13

Maintenance and care Cleaning with attachments (continued) A. Check manufacturer's tag before cleaning. "W" or "WS" on the tag means you can use your ProHeat. If the tag is coded with an "X" or an "S" (with a diagonal stripe through it), or says "Dry Clean Only", do not proceed with any deep cleaning machine. Do not use on Velvet or Silk. If manufacturer's tag is missing or not coded, check with your furniture dealer or manufacturer. B. Check for colorfastness in an inconspicuous place. C. If possible, check upholstery stuffing. Colored stuffing may bleed through fabric when wet. D. Plan activities to allow upholstery time to dry. E. Vacuum thoroughly to pick up loose debris and pet hair. Use a vacuum with a brush attachment and a crevice tool to clean in fabric folds. 2. Follow the instructions on page 9 for filling the water tank and the formula tank. 3. Set ready tools dial to the tools setting. This will allow spray and divert the suction to the hose. *SmartTemp heats the cleaning solution for carpet and hard floor application only. It does not heat solution sprayed through the accessory tools. 4. Set SmartMix dial to normal. 5. Attach the cleaning tool to the end of the hose. 6. Plug in and turn on the power switch. 7. Clean by pressing the trigger to spray solution onto the area to be cleaned. Slowly move the tool back and forth over the soiled surface. Release the trigger to suction soiled water. Continue to clean in the area, working in small sections, until no more dirt can be removed. Rinse (optional) and suction as needed. Caution: Do no overwet. 8. When cleaning is complete, remove and rinse tools in clean, running water. 9. Coil hose around the tool caddy. www.bissell.com ug120-4080_7350_908.indd 13 Manufacturer's tag WARNING: To reduce the risk of injury, be extra careful when cleaning stairs. Make sure machine is secure and level. 800.237.7691 13 10/14/08 1:27:01 PM