Bissell SpotLifterr 2X Essential Portable Carpet Cleaner 1719T User Guide - Page 5

Maintenance & Care Machine storage 1. Clean exterior surface of SpotLifter 2X with a soft cloth dampened with water only. Do not use a strong detergent or other cleaners as this may damage the finish. 2. Store SpotLifter 2X in a protected dry area, at room temperature (40° to 110°F). Tip » Check spray nozzle for accumulated dirt or debris. If necessary, clean with soft bristle brush. Battery removal and disposal Note: The battery must be removed from the Spot Lifter 2X before it is disposed of. 1. Important: Unplug charger. 2. Remove tanks (front and rear) and discard. 3. Remove screws (6) holding product housings together. 4. Use a screwdriver to score rating label on bottom of unit. 5. Separate housings and locate battery pack in bottom/center of unit. Note: If the battery is leaking, do not touch it. Contact your local authorities for a safe disposal or recycling facility in your area. 6. Remove wire connectors from the battery pack. 7. Keep battery pack together - DO NOT separate individual batteries. For specific disposal instructions of batteries, please contact: RBRC (Rechargeable Battery Recycling Corporation) 1-800-723-1297 or visit www.rbrc.com. 8. Discard remainder of product. WARNING This product contains a rechargeable nickel cadmium battery (sometimes referred to as a "Ni-Cad" battery) pack. The average life of a Ni-Cad battery is 5 to 7 years, depending on frequency of use. Proper removal and disposal of Ni-Cad batteries is required. 3. Screws Troubleshooting Problem Reduced suction or no suction Possible causes Collection/dirty tank is full Collection/dirty tank drain plug is loose Batteries weak/undercharged Collection/dirty tank not properly installed Remedies Empty collection/dirty tank Check plug for snug fit Recharge according to instructions Snap tank into place Reduced spray or no spray Solution/clean tank is empty Pump not primed Batteries weak/undercharged Spray tip clogged Refill solution/clean tank While SpotLifter 2X is turned on, press spray trigger and gently rock SpotLifter 2X back and forth Recharge according to instructions Rinse tip with clean water SpotLifter 2X is not powered or underpowered Charger plug/cord not connected Collection tank drain plug is loose Make sure charger plug is completely plugged into wall outlet and charging cord is completely plugged into port on back of unit. Make sure Spot Lifter 2X is stored with power switch in "O" (OFF) position Check plug for snug fit SpotLifter 2X will not charge Charger plug/cord not connected Batteries have charging resistance Make sure charger plug is completely plugged into wall outlet and charging cord is completely plugged into port on back of unit. Make sure Spot Lifter 2X is stored with power switch in "O" (OFF) position To recharge, first completely exhaust the battery, recharge it, then exhaust it once again before recharging a second time. This procedure may be required more than once Please do not return this product to the store. Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. For any questions or concerns, BISSELL is happy to be of service. Contact us directly at 1-800-237-7691. www.bissell.com 8 www.bissell.com 9