Bissell Trilogy Pet User Guide - Page 12

Maintenance and care Check rotating floor brush and drive belt It is recommended to check your vacuum's rotating floor brush and drive belt regularly for wear or 3 damage. 1. Turn power OFF. Unplug power cord from electrical outlet. 2. Place handle in low cleaning position turn vacuum over so bottom side is facing up. 3. Remove the six screws on the sole plate with Phillips head screwdriver and lift 4 brush cover off. 4. Grasp the rotating floor brush at both ends and lift out . 5. Clean hair, strings, and other debris from rotating brush, motor pulley, and drive belt areas. 6. Check air passageway for obstructions, remove any debris from this area. 7. Check drive belt carefully for wear, cuts, or stressed areas. If any damage is present, discard old drive and replace as instructed in following section. Replace drive belt 1. Turn power OFF. Unplug power cord from electrical outlet. 2. With rotating floor brush removed from 2 vacuum (steps 1-3 in previous section), grasp old drive belt and remove from motor pulley and around floor brush. Discard old drive belt. 3. Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles. 4. Place ends of rotating brush back down 3 into slots on sides of vacuum. 5. Turn floor brush by hand several times in the direction of motor pulley. If properly installed, drive belt should center itself on rotating brush. 6. Reposition brush cover and tighten securely with the six screws. 12 www.bissell.com 800.237.7691