Bissell Trilogy Pet User Guide - Page 6

Assembly Attach carpet spot & stain remover Pet holster 1. Locate the bag that contains carpet spot & stain remover holster and can. 2. Attach holster to left side of vacuum (when viewing from front) by lining up the two tabs on the back side of the holster with the two openings on the vacuum. Push holster down to lock into place. 3. Place provided can of carpet spot & stain remover*into holster. Follow instructions on page 8 for carpet spot & stain remover.* Operations Power cord To store power cord, wrap cord around upper cord wrap and lower extension wand support. Use clip on the end of the plug to attach plug to the cord. To release power cord, rotate the upper cord wrap down and gently pull off cord. Power switch Power Cord Wrap The power button is located just below the handle on the right side of the vacuum when viewing from the front."ON" (I) "OFF" (O) Note: Rotating brush will not turn on unless the unit is in reclined position and brush switch is on. Brush ON/OFF switch Brush ON/OFF is located just below the handle on the right side of the vacuum when viewing from the front. Push the rocker switch ON- (I) to turn brush on for most carpeted surfaces, when "ON" the brush will start rotating when unit is in reclined position. Push rocker switch OFF - (O) to turn brush off for bare floor cleaning or other delicate surfaces. Power Switch Brush ON/Off Switch ATTENTION: Some Frieze carpets have long delicate fibers or threads that may be damaged by the rotating brush during vacuuming. It is recommended the rotating brush be turned OFF when cleaning this type of carpet. * Carpet spot & stain remover varies by model. Refer to page 4. 6 www.bissell.com 800.237.7691