Bissell Vacuums User Guide - Page 8

Cleaning the Pre-Motor Filter WARNING To reduce the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. WARNING Do not operate vacuum with damp or wet filters or without all filters in place. 1 2 Press the tank release button and pull out to remove dirt tank. 3 Remove carbon and foam filter from lid. Hand wash in warm water and rinse well; mild detergent may be used if desired. 4 click Allow filter to air dry completely before placing back into the tank lid. The carbon filter should be on top of the foam filter. Return tank back on vacuum and press firmly until you hear a "click". Maintaining the TurboEraser® Tool 1 2 3 Twist gray collar counter-clockwise, until slot appears, then separate faceplate. 8 BISSELL.com Remove brush roll, belt, and paddle wheel. Inspect for damages and replace if necessary. To reassemble, align two clips on each end of paddle wheel with belt on and pop back into place. Place brush roll with belt back in. Faceplate will not close properly if all parts are not aligned correctly.