Bissell Vacuums User Guide - Page 10

Cleaning the Sensors After repeated use, debris can accumulate on the sensors of the robot and the robot's performance could be affected. To ensure the best efficiency, the sensors should be cleaned off periodically by brushing any debris from them. Turn the Power Switch OFF before cleaning the sensors. Sensors and Contacts 1. Cliff Sensors 2. Charging Contact Points 3. Soft Surface Avoidance Sensor 1 Replacing the Battery 13 1 2 2 1. Turn the Power Switch OFF. 2. Use a Phillips-head screwdriver to remove the two screws and battery cover. 3. Remove the battery and disconnect. 4. Connect the new battery and install into battery compartment. Do not remove the plastic shrink sleeve from the battery pack. 5. Use a Phillips-head screwdriver to replace the battery cover. Note: Any other servicing should be performed by an authorized service representative. WARNING This product contains Lithium-Ion rechargeable batteries. DO NOT mix Lithium-Ion batteries with general household waste. According to Federal and State regulations, removal and proper disposal of Lithium-Ion batteries is required. For specific battery disposal instructions please contact Call2Recycle at 877-723-1297 or visit www.call2recycle.org. WARNING To reduce the risk of electric shock, turn the Power Switch OFF before performing maintenance or troubleshooting checks. 10 BISSELL.com