Bosch B09IB80NSP Instructions for Use - Page 7
Preparing furniture doors, Connecting the appliance
View all Bosch B09IB80NSP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Preparing furniture doors Note: When working on furniture doors, always observe the following: ■ Select a furniture door thickness between at least 5/ 8" (16 mm) and 3/4" (19 mm). ■ Always select a screw length which is shorter than the thickness of the furniture door. ■ Always insert screws into the part of the furniture door which is best able to handle the load. ■ Do not insert screws into fillings, or similar. ■ Do not insert screws into filters, decorative strips, or similar. ■ Protect the furniture door surfaces against damage during installation. Furniture door dimensions PLQ PLQPP $ $ $ PP$ PLQ PP$ PD[ PP PP PP% PD[ PP% PLQ % % % Key A Furniture door protrusion B Lower edge of furniture door The specified furniture door dimensions apply for a door gap of 5/32" (4 mm). Connecting the appliance After installing the appliance, wait at least 8 hours until the appliance is switched on. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for the first time, clean the interior of the appliance (see chapter Cleaning the appliance). en-us Electrical connection , WARNING: Avoid the risk of an electric shock! , WARNING: Insert into a grounded 3-phase socket. Never remove grounding phase. Do not use any adapters. Do not use any extension cables. , WARNING: Non-compliance with these instructions may result in death, fire or an electric shock. Improper connection of the protective conductor may result in an electric shock. If you are in doubt whether the appliance has been grounded properly, have the appliance tested by a qualified electrician or service technician. Do not use extension cables or distributors. This appliance must be connected to a permanently installed socket. The socket must be near the appliance and also freely accessible following installation of the appliance. The appliance complies with protection class I. Connect the appliance to 115 V/60 Hz alternating current via a correctly installed socket with protective conductor. The socket must be fused with a 10 to 16 A fuse. The appliance comes with a UL registered 3-wire power cord. The appliance requires a 3-pole socket. Please observe the following table with regard to this: Appliance Fridgefreezer Maximum simultaneous load 6.0 amps Check on the rating plate whether the indicated voltage and current type correspond with the values of your power supply. The location of the rating plate can be found in the chapter entitled Customer service. , WARNING: Never connect the appliance to electronic energy saver plugs. Our appliances can be used with mains and sine-controlled inverters. Mains-controlled inverters are used for photovoltaic systems which are connected directly to the national grid. Sine-controlled inverters must be used for isolated applications (e.g. on ships or in mountain lodges) which are not connected directly to the national grid. 7