Bosch WFMC5301UC Installation and Use & Care (all languages) - Page 21

After, Washing, Cleaning - parts door seal

Page 21 highlights

After Washing The Start/Pause indicator light goes out. 0:00 appears in the display. q Open the door. q Turn the program selector to Off. q Close the taps. q Remove the laundry. i After washing, leave the loading door ajar to allow the inside of the washing machine to dry. Cleaning and Care Cleaning the washer d WARNING d TO AVOID RISK OF ELECTRIC SHOCK! Always disconnect the appliance from the power outlet before cleaning. Never clean the washing machine with a pressure washer. d WARNING d TO AVOID RISK OF EXPLOSION! Never use flammable solvents to clean the appliance. ATTENTION Occasionally check for any foreign objects (e. g. coins, paper clips) between the drum and rubber seal -To avoid risk of rust! Cleaning the appliance housing and control panel As required: q Use hot soapy water or a mild, nonĆabrasive cleaning agent. q Rub dry with a soft towel. Cleaning the drum If rust spots have formed due to leftĆover debris (e.g. coins, paper clips, nails): q Use a chlorineĆfree cleaning agent. Follow the manufacturer's instructions. Never use steel wool. Cleaning the detergent dispenser If residual detergents or additives have accumulated or if softener/bleach are not fully rinsed out: q Pull out the softener/bleach compartment in a vertical direction and remove. q Clean the detergent dispenser under running water. The detergent dispenser can be disassembled into two parts. q Insert the detergent dispenser until it clicks into place. Cleaning water inlet strainers This is necessary if very little or no water flows into the washing machine. First release the water pressure in the supply hoses: q Turn off the water taps. q Turn the program selector to any program. q Press Start/Pause button and wait approximately ten seconds. q Turn the program selector to Off. Cleaning the strainer(s) on the water tap In both the hot and cold water tap: q Open the flap of the detergent dispenser. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88

21
After
Washing
The
Start/Pause
indicator
light
goes
out.
0:00
appears
in
the
display.
q
Open
the
door.
q
Turn
the
program
selector
to
Off
.
q
Close
the
taps.
q
Remove
the
laundry.
i
After
washing,
leave
the
loading
door
ajar
to
allow
the
inside
of
the
washing
machine
to
dry.
Cleaning
and
Care
Cleaning
the
washer
d
WARNING
d
TO
AVOID
RISK
OF
ELECTRIC
SHOCK!
Always
disconnect
the
appliance
from
the
power
outlet
before
cleaning.
Never
clean
the
washing
machine
with
a
pressure
washer.
d
WARNING
d
TO
AVOID
RISK
OF
EXPLOSION!
Never
use
flammable
solvents
to
clean
the
appliance.
ATTENTION
Occasionally
check
for
any
foreign
objects
(e.
g.
coins,
paper
clips)
between
the
drum
and
rubber
seal
-To
avoid
risk
of
rust!
Cleaning
the
appliance
housing
and
control
panel
As
required:
q
Use
hot
soapy
water
or
a
mild,
nonĆabrasive
cleaning
agent.
q
Rub
dry
with
a
soft
towel.
Cleaning
the
drum
If
rust
spots
have
formed
due
to
leftĆover
debris
(e.g.
coins,
paper
clips,
nails):
q
Use
a
chlorineĆfree
cleaning
agent.
Follow
the
manufacturer's
instructions.
Never
use
steel
wool.
Cleaning
the
detergent
dispenser
If
residual
detergents
or
additives
have
accumulated
or
if
softener/bleach
are
not
fully
rinsed
out:
q
Open
the
flap
of
the
detergent
dispenser.
q
Pull
out
the
softener/bleach
compartment
in
a
vertical
direction
and
remove.
q
Clean
the
detergent
dispenser
under
running
water.
The
detergent
dispenser
can
be
disassembled
into
two
parts.
q
Insert
the
detergent
dispenser
until
it
clicks
into
place.
Cleaning
water
inlet
strainers
This
is
necessary
if
very
little
or
no
water
flows
into
the
washing
machine.
First
release
the
water
pressure
in
the
supply
hoses:
q
Turn
off
the
water
taps.
q
Turn
the
program
selector
to
any
program.
q
Press
Start/Pause
button
and
wait
approximately
ten
seconds.
q
Turn
the
program
selector
to
Off
.
Cleaning
the
strainer(s)
on
the
water
tap
In
both
the
hot
and
cold
water
tap: