Bose Acoustimass 10 Series II Owner's guide - Page 10
Surround cube speakers, Acoustimass module - home theater speakers
View all Bose Acoustimass 10 Series II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
English Setting Up Surround cube speakers The left and right rear channel sound should reach the viewer from both sides, rather than from directly behind. Refer to Figure 5. • Put one on the left and the other on the right, beside or just to the rear of the home theater seating area. • Place them high up, to avoid a direct sound path to the ears of the listeners (position 1). • If you want the speakers located as shown in positions 2 and 3, make sure they are not directed at the viewers. • The rear speaker on the left as you face the TV is connected to the LEFT SURROUND output jack on the Acoustimass® module. Figure 5 Suggested choices for surround (rear) speaker placement 1 1 2 2 3 3 Figure 6 Acoustimass module positions Acoustimass module Bose® recommends putting your Acoustimass module at the same end of the room as the television monitor. To prevent interference, keep the module at least 2 feet (.6 m) from the television. • You may hide the Acoustimass module behind or under furniture, but do not block the opening. Be sure there is at least 2 inches (5 cm) between the opening and any surface. • If the opening faces the wall it increases the bass; if it faces away it decreases the bass. For the most bass response, place the opening 2 to 3 inches (5 to 8 cm) from a wall or corner. • Stand the Acoustimass module vertically or horizontally (Figure 6). To stand it on the cable connection end, remove the cover by gently pulling it away. After selecting a place for the Acoustimass module, attach the larger set of four rubber feet to the bottom surface for additional stability. The feet protect the cable connections and must be mounted when the Acoustimass module is standing on that end. 8 October 22, 2001 AM19464_02_V.pdf