Bose Acoustimass 5 Series III Owner's guide - Page 12
Using your speaker system to its best advantage, Automatic System Protection, Receiver/amplifier
View all Bose Acoustimass 5 Series III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
English Fine Tuning Your Acoustimass® 5 Series III Speaker System Using your speaker system to its best advantage Your speaker system requires very little attention when set up and connected properly. However, observing the following guidelines will help maximize your enjoyment. Room Acoustics The acoustics (sound properties) of your listening room can affect the overall sound quality of any speaker system. The following tips will give you some control over the sound: A. Rooms with a lot of sound-absorbing furnishings, such as stuffed furniture, wall-to-wall carpet, or heavy drapes, may reduce the treble sound (high frequencies). The missing treble sound can be restored by slightly turning up the treble control on your receiver or amplifier. If convenient, you may remove some of the sound-absorbing material. B. Rooms with too few sound absorbing furnishings, especially those with bare floors and walls, may sound overly shrill or "bright" because of too much treble. Turning down the treble control or adding sound absorbers such as throw carpets or drapes will usually improve the sound. C. If your system seems to have too much or too little bass (low frequencies), you can adjust the bass control on your receiver or amplifier. You may also move the Acoustimass module closer to a wall and/or corner to increase bass. Doing the opposite will decrease bass. D. In general, many problems with acoustics can be solved by the judicious use of your tone controls. Remember, though, that the use of these controls (especially when turned all the way up) may put greater power demands on your receiver or amplifier. Excessive tone adjustment can cause an amplifier or receiver to run out of power and distort, potentially damaging your system. E. External signal processors (such as graphic and parametric equalizers), while not recommended, can be used with your Acoustimass 5 Series III speaker system if a greater degree of acoustic control is desired. Consult your Bose® dealer for advice. Automatic System Protection Note: The Acoustimass 5 Series III speaker system incorporates an automatic protection circuit, which guards against most kinds of damage from electrical stress or overload. This circuit activates at high volume levels to reduce output, causing a slight decrease in volume. This is normal operation and indicates that power input may be exceeding safe levels. Sustained listening at these levels is not recommended. Receiver/amplifier considerations Note: Your speakers incorporate heavy-duty driver elements designed to resist many types of electrical stress. However, any speaker can be damaged if the amplifier driving it fails. Increasing the volume until the music sounds distorted also causes speaker damage. This can happen even with a low-powered receiver or amplifier. Your speaker system is designed for use with receivers or amplifiers rated from 10 to 200 watts per channel with 4 to 8 ohm impedance. For further information, refer to your receiver or amplifier owner's guide. 10 October 23, 2001 AM196451_05_V.pdf