Bose Acoustimass 5 Series III Owner's guide - Page 7
Selecting the locations for your Acoustimass, system components, Examining the cables - receiver
View all Bose Acoustimass 5 Series III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
English Setting Up 2. Selecting the locations for your Acoustimass® system components 1. You can place the Acoustimass module almost anywhere in your listening room, in either a vertical or horizontal position (Figure 2). It can be hidden under a bed or table or even behind a sofa, as long as you remember not to block the round opening in the end of the unit. Allow at least 2 inches (5 cm) of space between that end and any surface. After selecting a place for the Acoustimass module, attach the four rubber feet to the bottom surface for additional stability. If you choose to stand the module on its connection end, the feet must be attached to protect the wire connections. CAUTION: The Acoustimass module is not magnetically shielded and should be kept at least two feet (.6 m) from a television. Figure 2 Acoustimass module positions -L+ - R+ OTOUCTUPBEUSTPSEAKERS - R + - FROIMNAPMUPTOSR RECEIVER L + -R+ TO OCUUBTE PSPUEATKSERS - L+ - R + - FROM AIMNPPOURTRSECEIVER L + 2. Next, select the positions for the left and right cube arrays. Remember that wires from the arrays connect to the Acoustimass module, so you should locate the cube arrays close enough to the module to enable the wires to reach it. The cube arrays are magnetically shielded, so they may be placed near a television. Note: Bose® wall brackets and floor stands can increase your placement options. See page 12 for details and ordering information. Note: While the wires provided are adequate for most installations, you may increase the distance between the cube arrays and the Acoustimass module by splicing in additional wire. If you do so, use similar gauge or thicker wire, and make sure you maintain the correct phase (+ to + and - to -), and properly connect the wires. 3. Examining the cables and connections Locate the four identical pairs of wires packed with the system. • Two wire pairs connect your cube arrays to the Acoustimass module. • The other two wire pairs connect the Acoustimass module to your receiver or amplifier. • Examine the ends of the wires. The marked wire (with a red, striped, or printed marker) connects to the positive (+) terminal at each connection. • The cube arrays and the Acoustimass module have red positive (+) connections. AM196451_05_V.pdf October 23, 2001 5