Bose Acoustimass 6 Series II Owner's guide - Page 11
Connecting the Acoustimass, module to the center and front, cube speakers, Connecting - surround system
View all Bose Acoustimass 6 Series II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
English Setting Up Your Acoustimass® 6 Speaker System Figure 9 Speaker cable connections to the cube speaker Connecting the Acoustimass® module to the center and front cube speakers CAUTION: Never connect the cubes directly to the receiver. Always connect the cube speakers to the Acoustimass module, then connect the Acoustimass module to the receiver. Use the 20 foot (6 m) cable with three pairs of wires to connect the Acoustimass module to the center and front cube speakers. Refer to Figure 8. 1. Connect the wire pair marked CENTER to the cube speaker you have placed in the center position. Press the terminal tab on the back of the speaker (Figure 9). Then insert the marked wire (+) into the red terminal and the plain wire (-) into the black terminal. Release the tab to secure the wires in place. AM252172_02_V.pdf 2. In the same way as in step 1, connect the wire pair marked RIGHT to the cube speaker you have placed in the right front position (to the right of the TV as you face it). 3. In the same way as in step 1, connect the wire pair marked LEFT to the cube speaker you have placed in the left front position (to the left of the TV as you face it). At the Acoustimass module, check to be sure the connectors are firmly inserted into the proper OUTPUTS TO CUBE SPEAKERS jacks. • The black L connector goes into the L jack. • The gray C connector goes into the C jack. • The black R connector goes into the R jack. Connecting the Acoustimass module to the surround cube speakers Use the 50 foot (15 m) cable with two pairs of wires to connect the right and left surround cube speakers to the Acoustimass module. Refer to Figure 8. 1. Connect the wire pair marked RIGHT SURROUND to the right surround cube speaker (on your right as you face the TV). Press the terminal tab on the back of the speaker (Figure 9). Then insert the marked wire (+) into the red terminal and the plain wire (-) into the black terminal. Release the tab to secure the wires in place. 2. In the same way as in step 1, connect the wire pair marked LEFT SURROUND to the left surround cube speaker (on your left as you face the TV). At the Acoustimass module, make sure the gray connectors are firmly inserted into the LS and RS OUTPUTS TO CUBE SPEAKERS jacks. October 29, 2001 11