Bose Acoustimass HT Owner's guide - Page 7

Setting Up - tier°undspeakers Wiese speakers provide surround sound effects at the rear of your viewing area (Figure 2). Brackets that come with these speakers allow you to mount them on the wall or ceiling in a vertical or horizontal position (see Note below). If you prefer, set the speakers on a table or shelf. For accurate surround sound: • Place the speakers as far apart as your room allows. • Make sure they are behind the general viewing area, along the rear wall or to the rear of side walls. • Place both speakers at the same height. • Keep these speakers at least 2 feet (.6 m) from your TV. • Where each speaker is placed determines whether it connects to the receiver outputs marked LEFT or RIGHT. • When you mount the speakers on brackets, be sure their position allows for room to tighten the bracket screw using a screw driver. Note:Ifyou use the supplied brackets, refer to the bracket instructions in the Appendix. Do not connect the speakers before reading those instructions. • To stand them vertically or horizontally without using brackets, apply the rubber feet to the bottom surface of the speakers (Figure 4). CAUTION: Do notplace the surround speakers within 2 feet (.6 m) of a TV or computer screen. The speakers are not magnetically shielded and will cause serious video interference if placed too close to a screen. CAUTION: The bracket screw must be inserted from the bottom on a vertically mounted bracket. Figure 4 Self-adhesive feet attached to a speaker in horizontal or vertical position Self-adhesive feet Self-ac hesive feet 7