Bose Acoustimass HT Owner's guide - Page 8
Connect, speakers
View all Bose Acoustimass HT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Setting Up Connect the speakers CAUTION: Use the supplied 20-foot speaker cables to connect the cube speakers to the Acoustimass` Before making any connec- module and the module to your receiver. Use the 50-foot cables to connect the surround tions, turn off your receiver speakers to your receiver. and unplug it from the AC • Note: if you need longer speaker cables, splice in 18-gauge (0.75 mm) or thicker cable. Make sure to attach the wires positive to positive and negative to negative. power (mains) outlet. Not doing so may result in damage to your system. Speaker cable consists of two insulated wires. The insulation around one wire is marked with a red band or stripe. This wire is always positive (+). The plain wire is always negative (-). These correspond to the positive (red) and negative (black) terminals on the back of each speaker or receiver. Be sure to connect each wire to the proper terminal, positive to positive and negative to negative. Cube speakers For each connection to the cube speakers, push the terminal tab down and insert the appropriate wire into the exposed hole (Figure 5). 1. Connect one end of a 20-foot cable to the right cube speaker. 2. Connect the other end to the RIGHT OUTPUT TO CUBE SPEAKERS terminals on the Acoustimass bass module (see Figure 6 on page 10). 3. Repeat to connect the left cube speaker to the LEFT OUTPUT TO CUBE SPEAKERS terminals. 4. Repeat to connect the center cube speaker to CENTER OUTPUT TO CUBE SPEAKERS terminals. CAUTION: Do not connect the cube speakers directly to the receiver. Black terminal tab (-) Plain ware (-) Figure 5 Inserting wire into cube speaker terminals